Purpose:
To describe the procedure for cleaning & usage of dispensing & transfer vessels
Scope:
This procedure is applicable for cleaning of dispensing & transfer vessel, capacity installed at ABC Limited.
Responsibilities:
Operator/Designee
|
To follow the instruction as per SOP.
|
Executive/Designee of Production Department
|
Execution as per the laid down procedure of SOP.
|
Head/In-charge Production
|
Monitoring and effective Implementation of SOP.
|
Head Quality Assurance
|
Approval & compliance as per SOP.
|
Procedure:
Cleaning Procedure
General Requirement
Cleaning Agent: IPA, Potable water, Purified water, Liquid Soap solution.
Cleaning Accessories: Lint free duster / lint free cloth, Nylon Brush.
Cleaning of Dispensing & Transfer Vessels
- Ensure that there is no product material kept/hold inside the vessel.
- Affix the “TO BE CLEANED” status label as per Quality Assurance SOP of status labeling & transfer it to washing area for cleaning.
- Open the top lid & discharge valve of the vessel.
- Rinse the top lid, internal & external surfaces of the vessels with potable water.
- Mope the top lid & surfaces of the vessels with 2% liquid soap solution using lint free cloth/lint free duster.
- Nylon brush may use to remove the stubborn material.
- Rinse top lid, internal and external surface of the vessels with potable water to remove the traces of 2% liquid soap solution.
- Finally rinse top lid, internal and external surfaces of the vessels with purified water.
- Dry the vessels with lint free cloth/duster/compressed air.
- Mope the surfaces of the vessels with IPA solution.
- Ensure that vessels and its parts are visually cleaned.
- Close the top lid and discharge valve of the vessels.
- Affix “CLEANED” status label on the vessels as per Quality Assurance SOP of status labeling and transfer it to cleaned equipment area.
- Every product to product change over.
- Change in color, flavor & essence of product material.
- Note: Mop the vessels with IPA solution every time before use
- Ensure that all the vessels shall be cleaned before dispensing.
- Carryout the required vessels to the dispensing area.
- After dispensing the material vessels move to manufacturing area through material
- air lock.